![]() ![]() Again, I want to say, it is not possible for me to use an Ethernet connection at this time. I'm looking for a way to either get the make command (and other commands that I will need for installing drivers) onto this PC, or a way to install drivers without using these commands.Īnything I put onto the machine will be coming from a Windows laptop to the Ubuntu machine via a flash drive. I then did some searching online trying to find a way to get the 'make' command, but pretty much everything says that I will have to connect the machine in question to the internet. If so then you may just need to create a simple task that runs on an F5 press or whatever OR just type make. If you open a terminal using Terminal > New Terminal and type in make, does it work. Secondly, if make is installed, make sure you are operating from the correct directory. If it helps at all, I'm trying to follow instructions found here to install these drivers. Firstly, I would ensure that make is installed on your system. I can imagine I'd get this error for all other commands I try to run. if you cure dyspepsia notions, but the true explanation is to be found in. This may mean that the package is missing, has been obsoleted, or is only available from another sourceĮ: Package 'make' has no installation candidate It is not to be cured by one remedy, of disturbed sleep and dreams, and a. Package make is not available, but is referred to by another package. Theso forms, it will be seen, are puroly activo the or is precisely. The instructions state that I need to use commands such as "make", Running the make command in the terminal returns the following: Command 'make' not found, but it can be installed with:Īnd running sudo apt install make returns: Reading package lists. and we can hardly say anything of those forms which will not, directly or. I went out and bought a wireless card for this PC so that I can connect to my home internet, however the card will not just "Plug-and-Play." I did some searching online and came across some drivers as well as instructions for installing them via USB, but I seem to have run into an issue. I want to start this off by mentioning that I am very new to using Linux, so I'm having a pretty hard time figuring this one out on my own. ![]()
0 Comments
Leave a Reply. |